Airbrush Cleaning

Cleaning the Air Brushes
Process:
How to clean the airbrushes with alcohol and a rag.
Definitions:
Any needed definitions
Procedure:
1. Remove the lid from the airbrush and pour any remaining paint back into the reservoir.
2. Wipe the inside of the airbrush bowl with a rag.
3. Fill 1/4 of the airbrush bowl with alcohol, plug the tip, and actuate the trigger.
  1. Allow the alcohol in the bowl to slosh for 5 seconds before emptying the bowl.
4. Repeat step 3 two to three times, as necessary.
5. Fill the airbrush bowl with two spays of alcohol and begin spraying.
  1. Repeat step 5 until the alcohol leaving the airbrush is clear.
6. Clean the outside of the airbrush and the bowl lid with alcohol and a rag.
7. Unscrew and remove the back cutaway handle.
8. Loosen the needle chucking nut.
9. Remove the needle from the back of the airbrush.
10. Clean the needle with alcohol and a rag.
11. Reinsert the needle, tighten the needle chucking nut, screw on the cutaway handle.
12. Do not actuate the main level while the needle is removed from the airbrush.
  1. Doing so may cause the main level to fall out.