Painting Black-Black Frame and Sash

Painting Black-Black Frames and Sash
Process:
            The process painting the corners of DQ frames. 
 
Definitions:
 
Procedure:
            Frame

1. Start by blowing off the frames on the rack to eliminate any excess debris left on frames.
   1. Be cautious of anyone standing near the blow off distance.
2. Place frames on table from rack.
3. After placing frames on the table, place bumpers by each corner of the frame to prevent color transfer onto other frames and giving enough room to dry properly.
4. Place precut cardboard on top of each corner to insure an even spray.
5. Using the air brush guns evenly coat the frame with the premade black paint.
   1. When painted slider frames or PM frames make sure to spray the inside of each corner covering all white lines top and bottom.
6. After spraying each corner on one side, flip the frame over and repeat steps 3-5.
7. After Both sides of frame are painted take the frame off the table. Place the frames on rack by the prep line Starting with the lowest sequence number. (ex. 1,2,3,4….)
8. When placing the frames on the rack ensure that the bumpers are secure between each frame to avoid color transfer.

Sash

1. Start off by blowing off any extra debris on the sash while the sash are still on the U-cart
   1. Be cautious of anyone standing near the blow off distance.
2. Place sash from U-cart on to the table.
3. Place precut cardboard on top of each corner to ensure an even spray and to avoid overspray.
4. Using the air brush guns evenly coat the frame with the premade black paint.
5. After spraying each corner on one side flip the frame over and repeat steps 2 and 3.
6. After completing both sides place sash back on U-cart starting with the lowest sequence number. (ex. 1,2,3,4….)