Studio Direct Set T-Bar Installation

Studio Direct Set T-Bar Installation
Process:
Overview of process
Definitions:
Any needed definitions
Procedure:
Silicone Attachment.

1. With the T-bar oriented to create an upside-down letter T, apply a bead of silicone to the head of the T and down the sides until the glazing bead cavity.
   1. Ensure each end of the T-bar receives silicone.
2. Insert the T-bar into the frame.
   1. Avoid smearing the silicone edges and compromising a future seal.
3. Apply a bead of silicone to the four pre-punched T-bar holes in the frame.
4. Attach the T-bar to the frame with two (#6 X 2” gold screws) on the outside of the nail fin and two (#8 X 3” gold screws) on the inside of the nail fin.
5. Clean off any silicone squeeze out from around the T-bar.

Gasket Attachment

1. Apply a Studio Direct Set T-bar Gasket to the end of the T-bar.
   1. Ensure each end of the T-bar receives a gasket.
2. Insert the T-bar into the frame.
   1. Avoid rolling the gasket and compromising a future seal.
3. Apply a bead of silicone to the four pre-punched T-bar holes in the frame.
4. Attach the T-bar to the frame with two (#6 X 2” gold screws) on the outside of the nail fin and two (#8 X 3” gold screws) on the inside of the nail fin.