Studio PW Frame Punch

Studio PW Punch
Overview:
            The process for punching weep holes in VS1 PW frame sills.
Definitions:
Procedure:

1. Remove paperwork from the cart and place at punch to verify each frame for correct size, color & profile while punching.
   1. Punch in order from top to bottom of cart.
   2. While verifying the size, verify the barcode label is on the jamb and not the sill.
2. Punch the weep holes in the sill.
   1. Studio is punched on the A76. 4 weep holes are punched per part.
   2. Insert sill piece into the punch all the way to the hard stop. Punch each part in each slot, no more than 2 parts at a time.
   3. Be sure to locate the part all the way to the hard stop to ensure the weep holes are punched in the correct location.
   4. If there are any more questions about punching, see the samples on the board.
3. Inspect the weep holes to ensure no material is left in the holes and the part is not deformed.
   1. Parts are to be replaced in the same slot they were removed from.
4. When the cart is complete, stage cart for the weld area.
   1. Once the cart is staged, sign off the frame punch log.